Extreme Networks Summit 200-24, Hardware Installation Manual

Page: 275 / 386

Configuring I/O Modules
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide 275
F48Ti Module
Figure 156 shows the F48Ti module.
Figure 156: F48Ti module
The F48Ti has 48 autosensing 10BASE-T/100BASE-TX ports. All ports use standard RJ-45 connectors.
The default configuration of the F48Ti module is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in auto-negotiation mode.
LEDs
The F48Ti module has the following LEDs:
•
Module status
• Port status
For information about the LEDs and their activity on the F48Ti module, see “I/O Module LEDs” on
page 293.
Software Requirements
The F48Ti module requires ExtremeWare version 6.1.4 or later.
XM_F48Ti
52011
DIAG STATUS
Module status LEDs
10/100 Mbps ports
with status LEDs