Exabyte VXA-2 AUTOPAK1X7, Product Manual, Page: 7 / 104

O
CTOBER
2002 E
XABYTE
VXA-2 A
UTO
P
AK1x7
A
UTOLOADER vii
A
BOUT
T
HIS
M
ANUAL
A
BOUT
T
HIS
M
ANUAL
This manual describes how to install, configure, operate, maintain, and
troubleshoot the Exabyte VXA-2 AutoPak
1x7
Autoloader. It also provides
autoloader specifications.
W
HERE TO
L
OOK FOR
I
NFORMATION
Installation
If you are performing first-time installation:
! Read Chapter 1 for an overview of the autoloader’s features and
components.
! Read Chapter 2 for installation instructions, including unpacking the
autoloader, obtaining the necessary accessories, connecting the autoloader
to a SCSI bus, and powering on the autoloader.
! Read Chapter 3 for configuration instructions, including how to use the
operator panel to set autoloader options.
Operation
When you are ready to put the autoloader into operation:
!
Read Chapter 4 to learn how to remove and replace the magazine, clean the
tape drive, reset the autoloader, and view autoloader information.
Maintenance, Troubleshooting, and Service
If you need to perform basic autoloader maintenance, troubleshoot problems,
or return the autoloader for service:
! Read Chapter 5 for maintenance information, including instructions for
uploading new firmware and creating diagnostic listings.
! Read Chapter 6 for troubleshooting tips, definitions of autoloader error
codes, and corrective actions for each error situation.
! Read Chapter 7 for packing and shipping instructions if you need to return
the autoloader for service.
Specifications
To learn about specifications for the autoloader:
! Read Appendix A for physical, performance, reliability, power,
environmental, and safety agency specifications.