30
P
RODUCT
M
ANUAL
1010964
Chapter
3
C
ONFIGURING
THE
A
UTOLOADER
You can set security in either of two ways:
!
You can set the security option from the LCD, as described in this section.
!
The application software can issue a SCSI MODE SELECT command to
enable or disable security (see your software documentation).
Whichever method you use to enable security (LCD or SCSI), you must also
use it to disable security. That is, if you enable security from the LCD, you
must disable it from the LCD.
Note:
The security setting is unaffected by cycling the power or resetting the
autoloader.
Enabling Security From the LCD
1.
1.
1.
1.
From the Status screen, press
[MENU]
. The following screen appears:
2.
2.
2.
2.
Disable LCD security, as described on
, if it is enabled.
3.
3.
3.
3.
Press
[ENTER]
to display the Security Menu. The following message flashes on
the screen:
Select password and press ENTER to enable security or
ESCAPE to cancel
Then, the following screen appears:
4.
4.
4.
4.
Select a three-digit password. Press
[
1
]
or
[
2
]
to move the screen arrow under
the digit in the password that you want to change and
[
3
]
or
[
4
]
to change
the number. (The default password is 000.) When you are finished, press
[ENTER]
.
5.
5.
5.
5.
A confirmation message appears. Press
[ENTER]
to accept the password and
enable security. Or, to exit without saving the password and without
enabling security, press
[ESCAPE]
.
!
S e c u r t y
D i s a b l e d
P W ?
0 0 0
←
↕
→
Important
You must use the same password to disable security.