Exabyte VXA-2 AUTOPAK1X7, Product Manual, Page: 24 / 104

16
P
RODUCT
M
ANUAL
1010964
Chapter 2 H
ARDWARE
I
NSTALLATION
3. 3. 3. 3. Plug the male end of the power cord into the power source.
Note: The autoloader has autoranging voltage selection, so you do not need
to change the voltage setting.
4.
4. 4.
4. Push the power switch on the back of the autoloader to the on position (the
I
is pressed). Wait while the autoloader performs its power-on sequence.
During this time, the following activities occur:
! The cooling fan begins to rotate.
! The LCD illuminates and displays the initialization sequence.
!
The drive and the autoloader perform their power-on self-tests.
! The LCD displays the Status screen.
5. 5. 5. 5. Power on the host computer system.
V
ERIFYING THE
H
ARDWARE
I
NSTALLATION
If the autoloader does not power on as described, check the following:
! Is the power switch on?
! Is the power cord inserted correctly?
! Is the SCSI bus terminated?
! Is the SCSI cable firmly connected to the autoloader and host computer?
! Is the host computer system powered on?
! Is the SCSI cable connected to the autoloader and host computer?
! Is there an error code displayed on the autoloader LCD? (See Chapter 6 .)
If you cannot resolve the problem yourself, contact Exabyte Technical Support
(see page iv ).
Figure 2-8 Connecting the autoloader’s power cord
Power switch
Power cord