Ericsson iPECS-100, Feature Description And Operation Manual

Page: 20 / 464

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
6
2.2 ALARM SIGNAL/DOOR BELL
Description
The system can be configured to recognize the status of an external contact (normally open or
closed). The system will signal assigned iPECS Phones when the contact activates. This
capability is commonly employed to provide remote Alarm or Door Bell signals to the user.
Assigned stations receive the Alarm Signal, either a single tone burst repeated at 1-minute
intervals or a continuous tone. The Alarm Signal may be terminated at the user
’s phone by
dialing the Alarm Stop code or, if assigned, pressing the {ALARM STOP} button. To rearm the
Alarm function, the alarm condition must be cleared and the Alarm signal terminated.
When used as a Door Bell, assigned iPECS Phones receive a single tone burst each time the
external contact is activated and no reset is required.
Operation
System
At detection of contact operation, the Alarm/Door Bell signal is sent to assigned stations.
iPECS Phone
To assign a Flex button as an {ALARM STOP} button to terminate the Alarm Signal:
[PGM] + {FLEX} +
“565” +
[SAVE]
To terminate an Alarm Signal while idle:
1. Dial the Flex Numbering Plan code 565, confirmation tone is received and the Alarm
Signal is terminated. If the alarm condition is cleared, the system will automatically
rearm the alarm monitoring.
Or,
2. Press the {ALARM STOP} button.
Conditions
1. The Alarm contacts must be
“dry”, no voltage or current source connected.
2. Only an iPECS Phone may be assigned to receive Alarm/Door Bell signals.
3. An iPECS Phone with LCD assigned to receive Alarm/Door Bell signals will show
“ALARM” or “DOOR BELL” as appropriate.
Programming
SYSTEM 1 Alarm Enable (PGM 163-Btn 1)
2 Alarm Contact Type (PGM 163-Btn 2)
3 Alarm/Doorbell Mode (PGM 163-Btn 3)
4 Alarm Signal Mode (PGM 163-Btn 4)
STATION 1 Alarm/Door Bell Attribute (PGM 113-Btn 8)
Related Features

Door Open