Environnement AS32M, Technical Manual, Page: 139 / 186

Duplication prohibited
AS32M
Environnement
S.A
DECEMBER 2013
5–15
Table 5-4 – Dialog-module (DIM) board configuration
Connector
Nature/Function Connection
J1 6V power supply cable of DIM board To be connected to J22 of the module board
J2 Preamplifier cable, DIM board/module board To be connected to J24 of the module board
J3 Preamplifier cable To be connected to the connection pins (2) of the
preamplifier board
J4 24 VCC power supply cable To be connected to the 24 VCC power supply
J5 LED cable To be connected to the light source (wired LED)
J6 Cable of heating laminar (block heating) To be connected to the heating laminar of the
measurement assembly (block heating)
J7 Link cable (2M Series) To be connected to J7 of the module board
J8 Not used Not used
J9 Seven-point flat cable - Module RS
communication To be connected to JP9 of the DNP-Arm7 board
J10 Seven-point flat cable To be connected to J35 of the module board
LD3 Frame of digital output Blinks at a frequency of two hits per second
Pt1 Photodiode signal coming from the
preamplifier board 0V > I <4,5V, 30 hits per second
Figure 5-5 – Dialog-module (DIM) board