Environnement AS32M, Technical Manual, Page: 135 / 186

Duplication prohibited
AS32M
Environnement
S.A
DECEMBER 2013
5–11
Table 5-2 – Module board configuration of the AS32M
Test point Signal Connector Connection
PT1 0 V (GND) J1 Pressure chamber
PT2 A/D RUN J2 AUX1 pressure sensor
PT3 A/D STATUS J3 AUX2 pressure sensor
PT4 +5VCC power supply J4 Not used
PT5 +15VCC power supply J5 Permeation bench temperature
PT6 0 V (GND) J6 Not used
PT7 Backup RAM voltage J7 Chamber heating control
PT8 -15VCC power supply J8 AUX2 heating
J9 AUX3 heating
J10 AUX4 heating
J11 Probe temperature
J12 Probe temperature
J13 Not used
J14 Not used
J15 Solenoid valve
J16 Solenoid valve
J17 Pump control
J18 Permeation bench control
J19 Fan
J20 AUX2
J21 AUX3
J22 Power supply 6 VCC carte DIM
J23 Power 24 VCC
Jumper Function
J24 Preamplifier (via DIM board)
J25 Not used
1
2
3
5V
J26 Not used
J27 Not used
SW1
Not used
1
2
3
24V (by-default
position)
J28 Not used
1,5V J29 Permeation bench supply ST1 (Power
supply DIM board)
6V (position to be
used)
J30 Stop 24 VCC
(by-default
position)
J31 Maintenance strap
ST2
Reset
microprocessor
J32 Bus i2C, ESTEL board (not used)
Inactive J33 Not used
ST3
Watch dog
Active (by-default
position)
J35 RS4i board (via DIM board)