Chapter 4
RVM Software
4-10
•
Selected Client
- Switches between the boards on the Multidrop Bus. M
C
1 is
found in the hexadecimal number range between 40 and 4
F
.
•
FW Version
- Indicates the firmware version of the
MC
1 board.
•
Actuators
- Shows the options for
MC
1’s actuators. Tap on the
Actuators
button
to switch to
Sensors
or
Thresholds
.
•
Safety Loop >>
- Indicates whether the safety loop is intact, broken, or overrid-
den. The status may be one of the following:
•
BRK
indicates that the door is open.
•
OK
indicates that the loop is intact.
•
OVR
indicates that the interlock is overridden by the key.
•
MC
1 indicates that the
MC
1 board has triggered a break in the loop.
•
Increase Counter
- Increases the mechanical counter by one.
•
Compactor Actuators
- The
Forward
and
Reverse
buttons are gray by default.
To activate these buttons, insert and turn the interlock override key, and then press
the receipt button. Once active, you can use the buttons to run the compactor for-
ward or reverse.
•
BC-Scanner Power
- Toggles power to the barcode scanner.
•
Camera Light 1
&
Camera Light 2
- Toggle power to the camera lights.
•
Relay 1
&
Relay 2
- Toggle power to the relays.
•
Button Lights
- Not used.
4.4.4. Ultra-48 Tab
The Ultra-48 tab is shown in Figure 4-10. The default screen shows the options for the Actuators. Tap
on
Actuators
to see the options for Sensors and Thresholds. The Ultra-48 actuators are controlled by
the
MC
5/
MD
5 boards. See Figure 4-11 to see where these components are located.
See Section 4.5 “Sensors and Thresholds” on page 4-15 for information about sensors and thresholds.
Warning!
Use extreme caution when operating a compactor with the doors open.
Keep your body and loose clothing away from moving parts.
Summary of Contents for U48DFF
