4-11
Diagnostic Program
FIGURE 4-10.
Diagnostics - Ultra-48 Tab
The following is a list of the Ultra-48 actuators:
•
Feed Belt
- Refers to the front feed belt. Use the buttons to advance the belt for-
ward, stop it, or reverse it.
•
Feed
LED
- Refers to the light at the front of the In-Feed. Use the buttons to turn
it on, change the color, or turn it off. Check the
RGB
box to enter
RGB
values for
the light color.
•
Sorter Belt
- Refers to the rear conveyor belt. Use these buttons to advance it for-
ward, stop it, or reverse it.
•
Sorter
- Turns the Sorting Cylinder. Use the
Left Bin
button to move the Sorting
Cylinder in the clockwise direction. Use the
Right Bin
button to turn it in the
counter-clockwise direction.
•
Barcode Rollers
- Refers to the rollers in the feed unit that turn containers. use
the
CW
button to turn the rollers in the clockwise direction. Use the
CCW
button
to turn the rollers in the counter-clockwise direction.
•
Elevator
- The elevator controls the vertical position of the rear of the front feed
belt. It lowers to allow the rollers to turn a container and raises to allow the belt to
push the container into or out of the feed unit. Use the
Up
and
Down
buttons to
change its position.
Note:
Check in the
Service Mode
box to use the actuator buttons.
Summary of Contents for U48DFF
