Enterasys Enterasys Matrix DFE-Gold Series, Configuration Manual

Page: 933 / 944

clear multiauth idle-timeout Configuring Multiple Authentication
Enterasys Matrix DFE-Gold Series Configuration Guide 27-11
Defaults
If no authentication method is specified, the timeout value is set for all methods.
Mode
Switch command, Read ‐ Write.
Usage
A value of zero indicates that no idle timeout will be applied unless an idle timeout value is
provided by the authenticating server. For example, if a session is authenticated by a RADIUS
server, that server may encode a Idle ‐ Timeout Attribute in its authentication response.
Examples
This example shows how to set the idle ‐ timeout session for cep and mac authentication to 500
seconds:
Matrix(rw)->set multiauth idle-timeout cep 500
Matrix(rw)->set multiauth idle-timeout mac 500
This example shows how to set the idle ‐ timeout session for all the authentication types to 600
seconds:
Matrix(rw)->set multiauth idle-timeout 600
clear multiauth idle-timeout
Use this command to reset the maximum number of consecutive seconds an authenticated session
may be idle before termination of the session to the default value of 300 seconds.
Syntax
clear multiauth idle-timeout [ cep | dot1x | mac | pwa ]
Parameters
mac (Optional) Specifies the authentication type Enterasys Mac
Authentication.
pwa (Optional) Specifies the authentication type Enterasys Port Web
Authentication.
timeout Specifies the timeout value in seconds. The value can range from 0 to
65535. A value of 0 means that no idle timeout will be applied unless an
idle timeout value is provided by the authenticating server. The default
timeout value is 300 seconds.
cep (Optional) Specifies the authentication type Enterasys Convergence
End Point Authentication.
dot1x (Optional) Specifies the authentication type IEEE 802.1X Port ‐ Based
Network Access Control.
mac (Optional) Specifies the authentication type Enterasys Mac
Authentication.
pwa (Optional) Specifies the authentication type Enterasys Port Web
Authentication.