Enterasys Enterasys Matrix DFE-Gold Series, Configuration Manual

Page: 561 / 944

show nodealias config Configuring Node Aliases
Enterasys Matrix DFE-Gold Series Configuration Guide 14-5
Parameters
Defaults
• If ip ‐ address is not specified for the IP protocol, IP ‐ related entries will be displayed from all
source addresses.
• If port ‐ string is not specified, node alias entries will be displayed for all ports.
Mode
Switch command, Read ‐ Only.
Example
This example shows how to display node alias entries for IP traffic on ge.3.16. Refer back to
Table 14 ‐ 1 for a description of the command output.
Matrix(rw)->show nodealias protocol ip ge.3.16
Port: ge.3.16 Time: 1 days 03 hrs 33 mins 47 secs
--------------------------------------------------------
Alias ID = 1533917141 Active = true
Vlan ID = 1 MAC Address = 00-e0-63-04-7b-00
Protocol = ip Source IP = 199.45.62.25
show nodealias config
Use this command to display node alias configuration settings on one or more ports.
Syntax
show nodealias config [ port-string ]
Parameters
ip | apl | mac | hsrp |
dhcps | dhcpc |
bootps | bootpc |
ospf | vrrp | ipx |
xrip | xsap | ipx20 |
rtmp | netBios | nbt |
bgp | rip | igrp | dec
| bpdu | udp
Specifies the protocol for which to display node alias entries. Refer back
show nodealias mac (“ show nodealias mac ” on page 14 ‐ 2) for a
detailed description of these parameters.
ip ‐ address ip ‐ address (Optional) Used for IP protocol only, displays node alias entries for a
specific source address.
port ‐ string (Optional) Displays node alias entries for specific port(s). For a detailed
description of possible port ‐ string values, refer to “ Port String Syntax
Used in the CLI ” on page 4 ‐ 2.
port ‐ string (Optional) Displays node alias configuration settings for specific
port(s). For a detailed description of possible port ‐ string values, refer to
“ Port String Syntax Used in the CLI ” on page 4 ‐ 2.