Enterasys Enterasys Matrix DFE-Gold Series, Configuration Manual

Page: 701 / 944

network Configuring RIP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-3
Parameters
None.
Defaults
None.
Mode
Router command, Global configuration: Matrix>Router(config)#
Usage
You must execute the router rip command to enable the protocol before completing many RIP ‐
specific configuration tasks. For details on enabling configuration modes, refer to Table 2 ‐ 8 in
“ Enabling Router Configuration Modes ” on page 2 ‐ 103.
The “no” form of this command disables RIP.
Example
This example shows how to enable RIP:
Matrix>Router#configure terminal
Matrix>Router(config)#router rip
Matrix>Router(config-router)#
network
Use this command to attach a network of directly connected networks to a RIP routing process, or
to remove a network from a RIP routing process.
Syntax
network ip-address
no network ip-address
Parameters
Defaults
None.
Mode
Router command, Router configuration: Matrix>Router(config ‐ router)#
Usage
The “no” form of this command removes the network from the RIP routing process.
ip ‐ address Specifies the IP address of a directly connected network that RIP will
advertise to its neighboring routers.