Enterasys Enterasys Matrix DFE-Gold Series, Configuration Manual

Page: 704 / 944

Configuring RIP timers
21-6 Routing Protocol Configuration
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config ‐ if(Vlan 1))#
Usage
Adding an offset on an interface is used for the purpose of making an interface a backup.
The “no” form of this command removes an offset.
Example
The following example shows how to add an offset of 1 to incoming RIP metrics on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip offset in 1
timers
Use this command to adjust RIP routing timers determining the frequency of routing updates, the
length of time before a route becomes invalid, and the interval during which routing information
regarding better paths is suppressed.
Syntax
timers basic update-seconds invalid-seconds holdown-seconds flush-seconds
no timers basic
Parameters
Defaults
None.
Mode
Router command, Router configuration: Matrix>Router(config ‐ router)#
Usage
The “no” form of this command clears RIP timer parameters.
basic Specifies a basic configuration for RIP routing timers.
update ‐ seconds Specifies the rate (seconds between updates) at which routing updates
are sent. Valid values are 0 to 4294967295 .
invalid ‐ seconds Specifies the interval (in seconds) after which a route is declared
invalid. Valid values are 1 to 4294967295 .
holdown ‐ seconds Specifies the interval (in seconds) during which routing information
regarding better paths is suppressed. Valid values are 0 to 4294967295 .
flush ‐ seconds Specifies the interval (in seconds) after which a route is deleted. Valid
values are 0 to 4294967295 .