Enterasys Enterasys Matrix DFE-Gold Series, Configuration Manual

Page: 245 / 944

set lacp Configuring LACP
Enterasys Matrix DFE-Gold Series Configuration Guide 4-59
Actor Partner
System Identifier: 00:e0:63:9d:b5:87 00:00:00:00:00:00
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 32768
Attached Ports: None.
Table 4 ‐ 9 provides an explanation of the command output.
set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device. LACP is enabled by default.
Syntax
set lacp { disable | enable }
Parameters
Defaults
None.
Table 4-9 show lacp Output Details
Output... What it displays...
Aggregator LAG port designation. Each Matrix Series module provides
4
virtual
link aggregator ports, which are designated in the CLI as lag.0.1
through lag.0.
4
. Once underlying physical ports (i.e.; fe.x.x , ge.x.x )
are associated with an aggregator port, the resulting Link Aggregation
Group (LAG) is represented with a
lag.x.x port designation.
Actor Local device participating in LACP negotiation.
Partner Remote device participating in LACP negotiation.
System Identifier MAC addresses for actor and partner.
System Priority System priority value which determines aggregation precedence. Only
one LACP system priority can be set on a Matrix Series
device, using
either the set lacp asyspri command (“ set lacp asyspri ” on
page 4-60), or the set port lacp command (“ set port lacp ” on
page 4-66)
.
Admin Key Port’s administratively assigned key.
Oper Key Port’s operational key, derived from the admin key. Only underlying
physical ports with oper keys matching the aggregator’s will be allowed
to aggregate.
Attached Ports Underlying physical ports associated with this aggregator.
Matrix
DFE-Gold Series devices allow for up to four ports per
aggregator.
disable | enable Disables or enables LACP.