Enterasys Enterasys Matrix DFE-Gold Series, Configuration Manual

Page: 478 / 944

Configuring System Logging set logging server
10-4 System Logging Configuration
Defaults
If index is not specified, all Syslog server information will be displayed.
Mode
Switch command, Read ‐ Only.
Example
This example shows how to display Syslog server configuration information. For an explanation
of the command output, refer back to Table 10 ‐ 1 .
Matrix(rw)->show logging server
IP Address Facility Severity Description Port Status
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5)
default 514 enabled
2 132.140.90.84 local4 warning(5) default 514 enabled
set logging server
Use this command to configure a Syslog server.
Syntax
s et logging server index [ ip-addr ip-addr ] [ facility facility ] [ severity severity ]
[ descr descr ] [ port por t] [ state { enable | disable }]
Parameters
index Specifies the server table index number for this server. Valid values are
1 ‐ 8 .
ip ‐ addr ip ‐ addr (Optional) Specifies the Syslog message server’s IP address.
facility facility (Optional) Specifies the server’s facility name. Valid values are: local0 to
local7 .
severity severity (Optional) Specifies the severity level at which the server will log
messages. Valid values and corresponding levels are:
1 - emergencies (system is unusable)
2 - alerts (immediate action required)
3 - critical conditions
4 - error conditions
5 - warning conditions
6 - notifications (significant conditions)
7 - informational messages
8 - debugging messages
descr descr (Optional) Specifies a textual string description of this facility/server.
port port (Optional) Specifies the default UDP port the client uses to send to the
server.
state enable | disable (Optional) Enables or disables this facility/server configuration.