9
Calibration
Note:
The preliminary calibration settings
are made at the main parameter
setting level on the menu
“Instrument data / calibration” (see
Chapter 7.5).
A direct route is taken to the relevant
calibration routine in accordance with the
type of calibration set on the menu
“Instrument data / calibration / calibration
parameters” (see Chapter 7.5). The screens-
hots can therefore deviate from the examples.
Sequence of operations
The code enquiry appears when the CAL key
has been pressed.
The whole of the calibration process is
accessible with the operator code.
If a retractable assembly is available that is
not yet in service position, this operation can
be actuated in the “Assembly” window by
selecting “Service”.
If the Chemoclean function has been
configured, a cleaning operation is also
possible.
The assembly and cleaning states are
displayed in an information window.
If the electrodes are calibrated individually in
two-circuit instruments (preliminary setting on
the menu “Instrument data / calibration /
calibration parameters”), a specific electrode
has to be chosen before the calibration
operation starts.
Conclusion of the calibration operation
The calibration operation is concluded by
commanding “Store calibration”.
If there is no assembly available, this field
appears.
If there is a retractable assembly, these fields
appear. If the Chemoclean function has been
configured, a cleaning operation is possible
as well. The assembly and cleaning states are
displayed in an information window.
CAL
↓
↓
↓
Calibration
mycom CPM 152
56
Hauser
