7.6
Chemoclean
7.6.1 Areas of application
Chemoclean is a system for cleaning
electrodes automatically. It requires an
instrument with an additional FCYK module
(total of 5 output contacts).
An injector (e.g. CYR 10) and an external
compressed air supply system are needed for
the Chemoclean functions »Cleaning agent«
and »Water«.
It is possible to activate a pneumatic
retractable holder in combination with the
Autoclean CPC 20 control system.
Feedback about the holder position is only
possible with the additional FCXI module.
7.6.2 Cleaning operation
• The appropriate settings for Chemoclean
have to be made first of all on the menu
»Instrument data / system configuration /
output contacts«:
– »Fault / clean / contacts« (clean, rinse,
two limit / control contacts)
– »3 alarms, clean« (clean, rinse,
maintenance and status contacts)
– »2 alarms, clean+assembly« (clean,
rinse, operate retractable assembly)
– »assembly« (operate retractable
assembly)
• The clean function »Chemoclean« must be
set in the
»
System configuration / output
contacts
«
menu
• »Chemoclean« functions are started via
the
»short-cut to relays« menu (see chapter
6.7)
Warning:
An external or internal hold
command does not have any effect
on Chemoclean. Chemoclean has to
be switched off whenever any work
is carried out on the assembly or the
electrode.
Note:
Access to the options
»Chemoclean« and »Set-up« is not
possible during a cleaning cycle.
When changes are made in the
»Set-up« menu, the cleaning cycle
starts from the beginning again.
→
Commissioning
→
Chemoclean
PARAM
Instrument configuration
mycom CPM 152
44
Hauser
