EMSD5 AC Servo Manual
Chapter 5 Running Mode and Wiring
43
5.2 Speed Control Mode Wiring
5.2.1 Introduction
Fig.5-3 Speed Control Mode
The main steps to use the speed control mode are as follows:
1)
correctly connect the servo main circuit and the power supply of the controller, as well as the
motor cable and encoder cable. The servo panel displays”r 0” after powering on which
means that the servo power supply and encoder connection are correct.
2)
Operate the servo JOG trial running mode through the panel keys to confirm whether the
motor can run normally.
3)
To connect the required DI/DO signals in CN1 terminal, such as servo enable, alarm
clearance, positioning completion signal, etc referring Fig.5-4.
4)
To operate speed mode related setting. DI/DO are used to set according to your application.
