CAM216/16 IOM
Doc. Number: ECM-402-0116
January 2016, Rev. 1
11
Section 2: Installation of CAM16
Installation of CAM16
b.
Select J5 Jumper in Multidrop Mode.
c.
Do the necessary changes in Host. It is important to make sure that all devices
to be connected in this mode have a different HART address. The HART
polling address can be found under the HART device information for each
device. Make sure that you connect one device at the time while changing the
addresses to avoid having devices with the same address on the network.
6.
HART Digital Control (Wireless THUM):
Refer to
Section 12
for details about the THUM wiring and configuration.
2.3
Installation of HART CAM16 in MPA Unit
1.
Remove power from the device and open the Local Display Module (LDM) by removing
the 4 screws on each corner. Access the internal electronics and locate the MPA CPU on
the back of the display. While opening the device, pay extra care to the connectors at
back of the CPU.
Figure 9
LDM Connectors
2.
Locate the P2 connector on the MPA CPU and the 3 plastic holders:
Figure 10
P2 Connector
