January 2016, Rev. 1
CAM216/16 IOM
Doc. Number: ECM-402-0116
10
Section 2: Installation of CAM16
Installation of CAM16
b.
Select the Jumper J5 in P2P Mode.
Figure 7
Jumper J5 in P2P Mode
J5
c.
For Analog mode, CAM16 – Connector J4, Pin 1 and 2 (CAM CARD 4 – 20 mA
Output) should be connected to Pin 1 and Pin 2 (Analog Input 1) of Connector
P1 of 320 B Board.
d.
Ensure that all connections from step 5 are properly secured among CAM16,
320B board and the HART Input signal. Then, tighten the screws and proceed
to close the unit.
5.
HART Digital Control (Multi-Drop):
a.
Connect the HART Analog 4–20 mA input signal as follows:
Figure 8
Connection of CAM16 with 320B Board
Table 11.
HART Control Types (6)
HART (+)
Connector J4, PIN 3
HART (-)
Connector J4, PIN 4
