![background image](http://html1.mh-extra.com/html/efka/dc-1500/dc-1500_instruction-manual_2367392017.webp)
EFKA FP220A5911
18
6.4 Changing All Parameter Values at the Operator Level
All parameter values at the operator level can be changed without code number input (see List of Parameters).
!
Press the
P
key
"
The first parameter number will be displayed
!
Press the
E
key
"
The parameter value will be displayed
!
Press the
+/-
keys
"
The parameter value will be changed
!
Press the
E
key
"
The next parameter will be displayed
!
Press the
E
key
"
The parameter value will be displayed
!
Press the
+/-
keys
"
The parameter value will be changed
etc.
!
Press the
P
key twice
"
Exit programming at the operator level
6.5 Function
Switchover
Switchable functions can be changed by pressing the appropriate key. The switching state is indicated by light emjtting
diodes (LED). See above illustration!
Table:
Assignment of functions to keys and LEDs
Function
Key
LED number
Single start backtack /
Chain suction at the start of the seam
E
(S2)
1 = on
2 = off
Double start backtack /
Chain suction at the seam end
E
1 = off
2 = on
Chain suction at the start of the seam / seam end
E
1 = on
2 = on
Start backtack Off /
Chain suction Off
E
1 = off
2 = off
Single end backtack /
Tape cutter at the start of the seam
+
(S3)
3 = on
4 = off
Double end backtack /
Tape cutter at the seam end
+
3 = off
4 = on
Tape cutter at the start of the seam / seam end
+
3 = on
4 = on
End backtack Off /
Tape cutter Off
+
3 = off
4 = off
Sewing foot lift at stop in the seam (automatic)
-
(S4)
5 = on
6 = off
Sewing foot lift at the seam end (automatic)
-
5 = off
6 = on
Sewing foot lift at stop in the seam and at the seam end (automatic)
-
5 = on
6 = on
Sewing foot lift (automatic) Off
-
5 = off
6 = off
Basic position down (position 1)
>>
(S5)
7 = on
8 = off
Basic position up (position 2)
>>
7 = off
8 = on
6.6 Direct Input of Maximum Speed Limitation without Control Panel
The maximum speed of the machine must be limited to the specific level according to the application. Do the setting at the
operator level on the control by means of the
+/-
keys during operation or at intermediate machine stop. This function is
blocked at the start of the seam or after the seam end. The actual value shown on the display must be multiplied by 10.
When using a control panel, the full speed value is displayed. See also chapter 7.4!
Example:
The value 330 on the control display corresponds to a speed of
3300 RPM.
Important!
If the speed is changed, it is saved only after trimming
and when you start sewing again.
LED3
LED4
LED5
LED6
LED7
LED8
LED2
LED1
S1
S5
S2
S3
S4
1 3 / K L23 2 8 a
P
E
LED7
LED8
LED1
LED2
LED3
LED4
LED5
LED6
S1
S4
S3
S2
S5
12 / K L2 32 7a
P
E