EFKA FP220A5911
77
240 = 21
Handwheel running in the direction of rotation:
Upon pressing the key, the drive runs in the opposite
direction of rotation according to the setting of parameter 161.
240 = 22
Speed limitation n11 (flip-flop 2):
Upon pressing the key in the seam, the speed limitation n11 is
enabled, and a signal is issued at the output ST2/29. The speed limitation will be disabled upon pressing
the key again, and the signal at the output is no longer issued.
240 = 23
No function
240 = 24
No function
240 = 25
Speed limitation with external potentiometer:
Upon pressing the key, the external speed limitation
becomes effective. Parameter 126 must be set at “2”.
240 = 26
Manual stacker:
Upon pressing the key, the function is performed in all modes (except mode 16).
240 = 27
Unlocking the chain:
Upon pressing the key, the function “unlock the chain” will be performed without
using the pedal.
240 = 28
External light barrier:
In this mode it is possible to initiate the seam end by means of a key, not by
means of the light barrier. But the light barrier function must be On.
240 = 29
Hemmer foot signal off:
See parameter 296. This function is effective only in the seam.
240 = 30
High lift for walking foot:
Upon pressing the key, high lift for walking foot is enabled if the sewing foot
is On.
240 = 31
Function “speed limitation bit0”:
Upon pressing the bit0 key, speed n11 will be enabled. Upon
simultaneously pressing the bit0 and bit1 keys, speed n9 will be enabled.
240 = 32
Function “speed limitation bit1”:
Upon pressing the bit1 key, speed n10 will be enabled. Upon
simultaneously pressing the bit0 and bit1 keys, speed n9 will be enabled.
240 = 33
Speed n9:
Below this speed, operation can be pedal controlled.
240 = 34
Automatic speed n9:
The speed can be suspended by pressing the pedal to position 0.
240 = 35
Automatic speed n9:
The speed can be interrupted by pressing the pedal to position -2.
240 = 36
Automatic speed n9:
No influence by the pedal.
240 = 37
Speed n12 with break contact:
Below this speed, operation can be pedal controlled.
240 = 38
Automatic speed n12 with break contact:
Not influenced by the pedal.
240 = 39
Switch to the next pattern in TEACH IN:
Upon pressing the key, the program switches to the next
pattern.
240 = 40
Switch back to the previous pattern TEACH IN:
Upon pressing the key, the program switches to the
previous pattern.
240 = 41
Tape cutting only at machine standstill
.
240 = 42
Enable hot thread chain cutting or sewing foot lifting:
This function is effective only in the chainstitch
mode.
240 = 43...47
No function
Input functions of parameters 241...249 are identical with those described for parameter 240.
11.34 Software Debouncing of All Inputs
Functions
Parameter
Software debouncing of all inputs
(EnP)
238
Parameter 238 = 0
No debouncing
Parameter 238 = 1
Debouncing
11.35 F1/F2 Function Key Assignment on the V810/V820 Control Panels
Functions
Parameter
Selection of input function on the (A) key "F1" on the V810/V820 control panels
(tF1)
293
Selection of input function on the (B) key "F2" on the V810/V820 control panels
(tF2)
294