EFKA FP220A5911
32
7.6.5 Deleting a Seam or Pattern
A pattern or seam can be deleted by means of the B
“DELETE F2“
key, on condition that the symbol above the pattern or
seam number is blinking during programming.
!
Select the pattern or seam number to be deletedc. The symbol above the pattern or seam number must be blinking.
Proceed as shown in chapters
“Programming with or without Code Number Input“
.
!
Press the B
“DELETE F2“
key twice in brief succession. The pattern or seam number will be deleted. All subsequent
numbers are automatically reduced by “1“. The following example shows how seam number 2 is deleted.
7.6.6 Execution (Pattern) Mode
!
Press the
0
key
"
The programmed seams are enabled. Arrow above the 0 key is On (but it does not blink).
!
Press the
+/-
key
"
Selection of pattern. Only if several patterns have been programmed.
!
Press the
E
key
"
If you do not wish to start with the first seam, select a different seam number. Press the E
key several times until the desired seam number is displayed.
!
The drive can now be started by pressing the pedal, and the pattern can be executed.
!
Press the
0
key
"
The programmed seams are disabled. Arrow above the 0 key is Off.
7.6.7 Further Settings for TEACH IN
Functions
Parameter
Seam suppression if 0 stitches are set
(Std)
321
Parameter 321 = 0 Seam suppression disabled:
i. e. if the light barrier is Off and stitch counting is set at 0 stitches, a
free seam will be performed.
Parameter 321 = 1 Seam suppression enabled:
i. e. if the light barrier is Off and stitch counting is set at 0 stitches, the
program switches to the next seam if the function is On. In case functions such as start of end
backtack, thread trimmer, signals A1 / A2 are On, they will be performed before switching to the next
seam.
Functions
Parameter
Correction seam On/Off, seam or pattern interruption by thread trimmer
(dkn)
322
Parameter 322 = 0 Correction seam disabled:
The seam can be interrupted by pressing the pedal to pos. –2. The control
switches automatically to the next seam number.
Parameter 322 = 1 Correction seam enabled:
-
The seam can be interrupted by pressing the pedal to pos. –2 and thread trimming, and a correction
seam (free seam) can be performed manually.
-
The correction seam can be completed by pressing the pedal to pos. –2 or by light barrier if it is
On. Then the control switches automatically to the next seam number.
K L2 3 9 4
DELETE
F2
K L2 3 9 5
DELETE F2
K L2 3 9 6
3 sec.
K L2 3 9 3
