EFKA FP220A5911
34
8 Putting into Service
Before putting the control into service, the following must be ensured, checked and/or adjusted:
!
The correct installation of the drive, position transmitter and accompanying devices, if necessary
!
The correct selection of the trimming operation by means of parameter 290
!
If necessary, the correct adjustment of the direction of motor rotation by means of parameter 161
!
The correct selection of the functions of keys (inputs) by means of parameters 240...249
!
The setting of the transmission ratio between motor shaft and machine shaft by means of parameter 272
!
The setting of the type of position sensor by means of parameter 270
!
If necessary, the setting of the number of angular degrees after the sensor position by means of parameter 271
!
If necessary, the setting of the positions by means of parameter 171
(possible with all settings of parameter 270)
!
The correct positioning speed by means of parameter 110
!
The correct maximum speed compatible with the sewing machine by means of parameter 111
!
The setting of the remaining relevant parameters
!
Start sewing in order to save the set values
9 Setting and Putting into Service with the Aid of the Fast Installation
Routine (SIR)
The Fast Installation Routine (SIR) passes through all parameters necessary for programming the functional sequence and
the positions.
Input parameter 500
"
Parameter for functional sequence
"
“thread trimming operations”
Parameter for direction of motor rotation
"
Parameter for transmission ratio
"
Important!
The transmission ratio should be
determined and indicated as precisely
as possible.
Parameter for type of position sensor
"
Parameter for position 1
"
Parameter for position 2
"
The values can be varied by pressing the +/- keys. When the parameter is displayed on the V810 control panel, press
the E key once more for the value to be displayed.
F-272
End SIR
F-451
F-453
F-270
No
P
E
E
E
E
Yes
K L243 8a
F-161
F-290
F-500
Code 3112
F-200
E
E
>>
E
E
