ECO-MATIC ESC 16, Operating Instructions Manual

Page: 84 / 128

16
Step 1 – Use a soldering iron with unleaded
solder to reattach the transformer &
cell cable wires to the PCB.
BMSC 13/20/26 110V & BMSC 13
220V: The order for reattaching the
wires to the PCB from left to right
are 1) orange, 2) white, 3) pink
which are the transformer wires,
the cell cable wires are soldered
onto the next three slots, the order
is 4) black, 5) blue, 6) black. The
blue cable represents the Gas
sensor which is marked on the PCB
with the word Gas.
BMSC 20 – 26 220V: From left to
right the order for the cables to be
soldered are 1) red, 2) black & 3)
white which are the transformer
wires, the cell cable wires are
soldered onto the next three slots,
the order is 4) black, 5) blue, 6)
black. The blue cable represents
the Gas sensor which is marked on
the PCB with the word Gas.
Assembly
Step 2 – When PCB is in place the sanitiser
output holder will be visible
poking through the front panelling.
Reconnect sanitiser output knob
to its holder ensuring it is able to
be adjusted to both minimum &
maximum settings.
Step 3 – Screw the protective cover for the
PCB back on using a Phillips head
screw driver (one point).
1. ORANGE
1. RED
4. BLACK
4. BLACK
2. WHITE
2. BLACK
5. BLUE
5. BLUE
3. PINK
3. WHITE
6. BLACK
6. BLACK