ECO-MATIC ESC 16, Operating Instructions Manual

Page: 81 / 128

13
Step 1 – Place transformer over the locating
screw.
Step 5 – With a soldering iron & solder
sucker or solder wick remove the 3
transformer wires. The transformer
wires are the red, black & white
wires on the top left corner of the
PCB. When the metal has cooled
remove the transformer wires.
Note the placement of the wires
on the PCB so as to enable easier
reassembly.
Assembly
Step 2 – Place heat dispersion disk over the
transformer with the shiny metallic
side face up. Place flat washer
in place over the locating screw,
tighten the transformer nut using an
8mm spanner.
Step 6 – Remove the nut on the top of
the transformer with an 8mm
spanner then lift off the black
heat dispersion disk which when
removed allows for the transformer
to be lifted out of the chlorinator.
When removing heat dispersion
disk also remove the flat washer
located beneath the nut.
BLUE
BROWN