ECO-MATIC ESC 16, Operating Instructions Manual

Page: 23 / 128

21
Start-Up Procedure
Refer to your ECO-matic Owner’s Guide for an explanation of ECO-matic’s various Operating Modes, including its
30-second Start-Up Phase (which occurs each time your ECO-matic is switched ON).
NOTE: The ON/OFF switch on the front control panel of your ECO-matic can be left in the ON position (other than at
times when you want the ECO-matic to be OFF while the filter pump is operating). The Timing device or switch which
turns your filter pump ON and OFF will also switch the ECO-matic ON and OFF (providing the electrical connection to the
‘Power Pack’ has been done correctly).
Ongoing Adjustment Of The ECO-matic
Repeat the above (testing sanitizer level daily) until you get a consistent sanitizer reading each day. The Output Control
(and/ or daily filtering time) will then only need to be altered according to fluctuations in pool use, seasonal changes in the
weather and pool water temperature. Your pool ‘Test Kit’ is your ONLY INDICATOR as to whether the Output Control or
daily ECO-matic operating time needs to be altered.
NOTE: The SALT LEVEL and SANITIZER LEVEL are not the same thing and should both be maintained as per
your ECO-matic Owner’s Guide.
Warranty Information:
ECO-matic Manufactured by:
Davey Water Products Pty Ltd
Member of the GUD Group
ABN 18 066 327 517
Head Office and Manufacturing
6 Lakeview Drive,
Scoresby, Australia 3179
Help to find a Dealer: help@ecomatic.com Parts or Service: Phone 877-885-0585
Your local ECO-matic Dealer:
What To Do - Day 1
Once your ECO-matic is operational, adjust the System
Control to suit the existing ‘chlorine’ reading in the pool
water. If the existing ‘chlorine’ reading is low or zero,
adjust the System Control to maximum and run the
system until the desired sanitizer level is measured in
the pool. If the existing ‘chlorine’ reading is high, the
System control can be set low (or the ECO-matic can
be left OFF until the chlorine level drops)
Operate the filter at least 12 hours (preferably all day)
What To Do - Day 2
Check the sanitizer level in the pool water (refer to
Owner’s Guide). Adjust the System Control and/or filter
operating time accordingly (refer Owner’s Guide).
It is best to check the sanitizer level at approx the
same time of day (mornings are best) so you get a
true indication of whether the ECO-matic is producing
sufficient, too much or too little sanitizer each day.
(This warranty is applicable to the USA and Canada only)
The ECO-matic® & EcoSalt® product is warranted that if any component, other than fuses, proves to be defective within
a period of 3 years from the date of purchase, that the defect will be repaired or the product will be replaced free of
charge. ECO-matic and EcoSalt replacement cells are warranted for a period equal to the greater of A) 1 year from the
date of purchase or B) the remainder of the full warranty on the unit.
During the Warranty period any defective product shall be repaired or replaced by an authorized warranty station or
returned by the customer to its place of purchase, accompanied by proof of date of purchase. Product will either be
repaired or replaced and returned freight prepaid. If proof of date of purchase is not available, then the manufacturer’s
data code stamp on the unit and/or cell will be used to determine warranty qualification.
There is no responsibility other than the repair or replacement of defective product and this Warranty specifically
excludes product failure due to accidental damage, abuse, misuse, negligence, damage due to non-compliance with
Installation or Operating Instructions or unauthorized alterations or modifications to the product. No responsibility or
liability accepted for any extended warranties or variations to this warranty offered by re-sellers.