ECO-MATIC ESC 16, Operating Instructions Manual

Page: 44 / 128

18
Step 1
– Using a soldering iron & a
solder sucker remove the wires
connected to the Triacs. Mark the
positioning of the wires to assist in
reconnection.
Step 1 – When placing the Triacs back
onto the chlorinator use a heat
transfer compound such as Unick
to assist with heat dispersion
during operation. Unick is generally
available from electrical repair
stores & some electronic retailers.
Fasten the Triacs down using a
Phillips head screwdriver (two
point).
Disassembly
Assembly
Step 2
– Remove the screws connecting
the Triacs to the chlorinator using
a Phillips head screwdriver (two
point) & remove the Triacs.
Step 2 – Using a soldering iron reconnect
Triac wires to their correct
locations. The position of the wires
to solder back onto the lower Triac
from left to right is 1) Blue PCB
wire & Solder Bridge, 2) White
PCB wire, 3) White transformer
cable with the black PCB wire. The
position of the wires on the top
Triac from left to right is 4) Solder
Bridge, 5) Yellow PCB wire, 6)
White transformer cable with green
PCB wire.
Replacing the
Triacs –
ESC 36 - 48 220V
1. BLUE/SOLDER BRIDGE 4. SOLDER
BRIDGE
2. WHITE
5. YELLOW
3. WHITE, WITH
BLACK PCB
6. WHITE, WITH
GREEN PCB