ECO-MATIC ESC 16, Operating Instructions Manual, Page: 100 / 128

4
Step 1 – Remove transformer wires from
the terminal strip using a flat blade
screwdriver (3mm). Mark the wires
to enable easier connection on
reassembly.
Step 3 – Remove the ORP control knob
which will allow you to move the
PCB to the side. May need to use
two flat blade screwdrivers to lever
the knob off if it is fastened too
tight to remove by hand. If using
screwdrivers be careful not to
damage the control panel.
IMPORTANT NOTE: Power MUST be switched off before removing transformer.
Note: Wiring assembly differs between 110V & 220V Ecospa where indicated.
Disassembly
Step 2 – Remove the screws holding the
protective cover on the PCB with
a Phillips head screwdriver (one
point).
Step 4 – Remove the wires connecting the
transformer to the PCB using a flat
blade screwdriver (3mm).
Note: this is all the wires on the
PCB terminal strip except the
brown & dark blue wires.
Mark the removed wires to enable
easier connection on reassembly.
Replacing the
Transformer