Operation and Maintenance
Eaton Network Card-MS User’s Guide P-164000100—Rev 1
www.eaton.com/powerquality
72
l
Modify Network settings:
To modify existing network parameters (see Figure 47). Restart the card to activate
the new parameters. In DHCP mode, the card can receive the following parameters according to the DHCP
server settings:
- IP address
- Subnet mask
- Gateway address
- Primary DNS server
- Secondary DNS server
Figure 47. Modify Network Settings
l
Set Ethernet speed:
To change the network speed (see Figure 48). Restart the card to activate the new
parameters.
Figure 48. Ethernet Speed Settings
Option 3: Set Login Password to Default
Select menu item
3
to return the password to the default (
admin
). Wait for the confirmation message
(see Figure 49). The card is now accessible using the Web with the default password admin, but you must
restart the card to save the new password.
Figure 49. Default Password Confirmation Message
For each of the following questions, you can press <Return> to select the
value shown in braces, or you can enter a new value.
S
hould this target obtain IP settings from the network?[N]
S
tatic IP address [xxx.xx.xxx.129]?
S
ubnet Mask IP address [255.255.xxx.0]?
Gateway address IP address [xxx.xx.xxx.1]?
Wait while your new configuration is saved ...
Reset the card to enable the new configuration.
S
et the Ethernet speed : [1 : Automatic, 2 : 10 MBit]
1
New Ethernet speed : Automatic
Wait while the new setting is saved...
Reset the card to enable the new configuration.
Login Password has successfully been set
