![background image](http://html1.mh-extra.com/html/eaton/network-card-ms/network-card-ms_user-manual_3779478002.webp)
Class B EMC Statements
FCC Part 15 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and the receiver.
l
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l
Consult the dealer or an experienced radio/TV technician for help.
Requesting a Declaration of Conformity
Units that are labeled with a CE mark comply with the following harmonized standards and EU directives:
l
Safety for ATI: IEC/EN 60950-1 2002
l
EN 61000-6-2 (2002)
EN 61000-6-3 (2002)
IEC/EN 62040-2 (2002).
l
EU Directives: 99/336/EEC and 93/68/EEC.
Low voltage: 73/23/EEC and 93/68/EEC.
The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC
Declaration of Conformity, contact:
Eaton Power Quality Oy
Koskelontie 13
FIN-02920 Espoo
Finland
Phone: +358-9-452 661
Fax: +358-9-452 665 68
Eaton is a registered trademark of Eaton Corporation or its subsidiaries and affiliates. Phillips and Pozidriv are a
registered trademarks of Phillips Screw Company. National Electrical Code and NEC are registered trademarks
of National Fire Protection Association, Inc. All other trademarks are properties of their respective companies.
©Copyright 2011 Eaton Corporation, Raleigh NC, USA. All rights reserved. No part of this document may be
reproduced in any way without the express written approval of Eaton Corporation.