![background image](http://html1.mh-extra.com/html/eaton/network-card-ms/network-card-ms_user-manual_3779478040.webp)
Configuring the Card
Eaton Network Card-MS User’s Guide P-164000100—Rev 1
www.eaton.com/powerquality
34
Select
Email Notification
from the menu bar to configure e-mail recipients (see Figure 27).
Figure 27. Email Notification Page (Shown with Environmental Monitoring Probe [EMP] option)
On the Email Notification page, you can configure up to four recipients in the Recipient list to receive e-mail
messages initiated by the card. Each recipient receives an e-mail message based on specific trigger events,
selected from the right side of the page. The card’s log also indicates e-mail transmission errors.
Each recipient is configured with the following parameters:
l
Recipient (limited to 99 characters):
The e-mail address of the person or department to receive the e-mail.
The default value is [email protected].
Select
Enabled
to enable the recipient to receive e-mail messages.
Enotify:
In addition to the Recipient list, you can include Eaton’s eNotify Remote Monitoring and Diagnostics
Service.
l
Attached files:
The files selected (Measurements, Event log, System log, Environment Log) are attached to
the e-mail message. The files are sent in CSV format.
l
Periodic report:
In addition to the e-mail messages sent when events occur, you can send to the recipient at
specified intervals a periodic e-mail message with the three (optionally four) log files attached. To configure
the first transmission, specify the day, time, and frequency of the next transmission. After this date, the
page shows the date and time of the next transmission. Data is sent in CSV format.
l
Email Message Settings:
Access to the message configuration page.
l
Network Settings:
Enables you to enter the name of the SMTP server (see “Network Settings” on page 37).