Eaton Managed ePDU, User Manual

Page: 15 / 129

EATON
Managed ePDU User’s Guide 164201xxx Rev 1
DRAFT 10−OCT−2008
5
Chapter 2
Safety Warnings
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important instructions that you should follow during installation and operation of the
ePDU. Please read all instructions before operating the equipment and save this manual for future reference.
D A N G E R
This ePDU contains
LETHAL VOLTAGES
. All repairs and service should be performed by
AUTHORIZED
SERVICE PERSONNEL ONLY
. There are
NO USER SERVICEABLE PARTS
inside the ePDU.
SYSTEMS SHOULD ONLY BE CONFIGURED BY A COMPETENT PERSON.
IT IS ESSENTIAL THAT THIS EQUIPMENT IS CONNECTED TO AN ELECTRICAL SUPPLY THAT HAS A
PROTECTIVE GROUND CONDUCTOR
WARNING: TO ISOLATE THIS EQUIPMENT DISCONNECT POWER SUPPLY PLUG.
ATTENTION: AFIN D’ISOLER TOTALEMENT CET APPAREIL DEBRANCHER FICHE D’ALIMENTATION.
CAUTION: USE ONLY IN DRY LOCATIONS.
ATTENTION: UTILISER UNIQUEMENT DANS DES EMPLACEMENTS SECS.
W A R N I N G
To avoid potentially fatal shock hazard and possible damage to Eaton equipment:
Do not use a 2−wire power cord in any product configuration.
Test AC outlets at your computer and monitor for proper polarity and grounding.
Use only with grounded outlets at both the computer and monitor. When using a backup UPS, power the
computer, monitor and appliance off the supply.
The installation socket outlet used for the power supply to this equipment must be installed near the
equipment
and must be easily accessible.
When installing this product, it is essential that the distribution circuit supplying the product is protected
by a branch circuit protection device with a maximum rating to suit the product maximum rating.
TO ISOLATE THIS EQUIPMENT DISCONNECT POWER SUPPLY PLUG
.
This power distribution unit is intended for power supply provision to equipment only. Secondary
(Satellite) power strips shall not be connected to the receptacles.
This product has been designed to conform to the latest safety requirements. In addition to compliance
with standards for general use, it has been factory configured for use in rack mounting environments
aiding the installer to provide systems compliant with relevant standards.