Eaton Managed ePDU, User Manual

Page: 102 / 129

USING THE CLP INTERFACE
EATON
Managed ePDU
t
User’s Guide
S
164201xxx Rev 1
DRAFT 10−OCT−2008 92
Showing Outlet Information
The show command displays the name, power state (on or off), and associated
sensors for one outlet or for all outlets.
Syntax
The following is the syntax for the
show
command:
clp:/ − > show /system1/outlet<outlet number>
where <outlet number> is the number of the outlet. To display information for all
outlets, type the wild card asterisk (*) instead of a number.
Attributes
You can use the
name
and
powerState
attributes to filter the output of the
show
command. The
name
attribute displays only the name of the outlet, and the
powerState
attribute displays only the power state (on or off).
The following shows the syntax for both attributes:
clp:/ − > show –d properties=name /system1/outlet<outlet number>
clp:/ − > show –d properties=powerState
/system1/outlet<outlet number>
where <outlet number> is the number of the outlet. In both cases, the outlet number
can also be a wild card asterisk (*).
Examples
Figure 95 shows an example of the output when a
show
command is entered without
attributes.
Figure 95. Example 1 – No Attributes