Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 5
119
11. Enter the part number of your ePDU in the Eaton Product Wizards “ePDU Part Number Search” field. Click
Search
. The Search Results page displays (see Figure 87).
Figure 87. Search Wizard
12. On the Search Results page, click the linked part number under the part number column. The Product
page for the specified ePDU opens (see Figure 88).
Figure 88. Search Results
13. Copy and save the ePDU model-specific hardware configuration file to your computer using the link near
the bottom of the page.
!
IMPORTANT
Be sure that the Configuration number on the unit rating label also appears in the file name of the
model-specific ePDU hardware configuration file.
14. Go to Step 21.
15. Make sure the eNMC module is powered ON. Connect a USB flash drive to a working ePDU.
!
IMPORTANT
This ePDU must be of the same model type and configuration as the ePDU that houses the eNMC
you will replace.
16. When the LCD interface pop-up confirms that the USB flash drive is detected, click OK, and press Enter to
return to the Main Menu. (If not confirmed within 10 seconds, the pop-up goes away by itself.)
17. From the Settings menu, select USB Flash Mode. Press Enter, select yes to confirm, and then press Enter
again. The module restarts. (If there is no action within one minute, the eNMC module exits USB Flash
Mode. Remove and reinsert the flash drive to access this menu again.)
18. Select Save eNMC file to save the ePDU hardware configuration file to the USB drive. The file will save to
the eNMC/config/hw path at the USB drive root directory (see Figure 89).
NOTE
The link to the configuration file only displays if you are signed in.