LCD Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5
62
6.
When the pop-up confirms that the USB is detected, click
OK
, and
then press
Enter
to return to the Main
Menu. (If not confirmed within 10 seconds, the pop-up goes away by itself.)
7.
Select USB Flash Mode. Click
Yes
to confirm you want to enter the USB Flash mode. (If there is no action
within one minute, the eNMC module exits the USB Flash mode. Remove and reinsert the USB drive to
access this menu again.) The module restarts.
8.
Select Upgrade FW and click
OK
to confirm the upgrade (see Figure 68). The eNMC module gets the file
from the USB drive.
Figure 68. Example Select Upgrade Firmware
9.
A few seconds after 100% is reached, the eNMC module restarts and then enters in Boot upgrade mode
to continue upgrade. The upgrade is finished when eNMC module is restarted. This can take several
minutes (see Figure 69).
Figure 69. Example Upgrade in Progress
Exit
Select
Exit
to leave USB Flash Mode.
Display Submenu
The Display submenu allows you to customize settings for LCD contrast and orientation (see Figure 70).
On the Settings menu, scroll up or down to highlight
DISPLAY
. Press
ENTER
to display the screens to set the
values for the submenu. After you select the values, press
ENTER
to set the values as displayed on the screen.
Press
ESC
to return to the previous menu.
Figure 70. Example Display Submenu Displays
Daisy Chain
Settings
LCD
IPv4
Factory
Display
Language
ESC
Enter
Main Menu
Active Alarms
Alarms History
Meters
Control
ePDU Info
Main Menu
Settings
Enter
ESC
USB Flash Mode
Main Menu
.
Exit
USB Flash Mode
Save Config
.
Load Config
Save eNMC file
Load eNMC file
Upgrade F/W
ESC
Enter
USB Upgrade F/W
Current Vers.
00.00.0021
Main Menu
USB Upgrade F/W
Current F/W
version.
00.00.0021
Upload
45 %
ESC
Enter
Load Config.
Save eNMC file
Load eNMC file
Exit
USB Flash Mode
Save Config
.
Upgrade F/W
Contrast:
Orientation:
LCD
35
0 °
Contrast:
Orientation:
LCD
35
0°
90°
180°
- 90°
0 °
90°
ESC
Enter
Enter
Enter
Display
Daisy Chain
IPv4
Factory
Settings
Display
Language