Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5
93
4.
To modify environment threshold values, or to receive alarms when dry contacts change state, click the
Settings
button located in the lower, right-hand corner of the Web interface screen. The Environment
Settings dialog displays.
5.
To select default values for thresholds or dry contacts, click
Default
.
6.
To enter new threshold values, type new values in any of the text boxes that follow, then click
Save
:
l
Low critical humidity alarm threshold
l
Low warning humidity threshold
l
High warning humidity threshold
l
High critical humidity alarm threshold
l
Low critical temperature alarm threshold
l
Low warning temperature threshold
l
High warning temperature threshold
l
High critical temperature alarm threshold
7.
To choose if you are notified when a dry contact state changes (Open or Closed), select one of the
settings from the drop-down list under Open or Closed for the specified contact, then click
Save
:
l
Informational
: No alarm is generated.
l
Alarm
: An alarm is generated when the specified dry contact is Open or Closed.
8.
To reset the threshold values to the default values, click
Default
, then click
Save
.
9.
To cancel this action and return to the Environment page, click
Cancel
.
NOTE
The environmental monitoring data panel displays the value of the last EMP value
read as follows:
l
When the EMP is disconnected, the startup value will be 0 (zero).
l
When the EMP is first connected, the startup value will be 0 (zero) because the
last known reading was taken before a sensor was connected.
l
When the EMP remains connected, the startup value is the last known EMP
reading.
NOTE
In the Environment Settings dialog, the measure column displays the present status
or state of the dry contacts. This is a read-only column.
NOTE
To change the temperature scale to Celsius or Fahrenheit unit of measurement (°C
or °F), see “Set General System Settings” on page 101.