STEP 1:
Select a location close to the equipment. In the case of a flat panel
display, the recommended location is one that is behind the device
and hidden from view once the Plasma TV is mounted. Cut a 4”
wide by 3 3/4” high hole in the wall for the mounting bracket.
STEP 2:
Run the signal line(s) through the mounting bracket.
Install the mounting bracket in the hole.
STEP 3:
Remove the rubber plug from one of the Signal Bay Pass-
Throughs. Cut a hole in the rubber plug so that it fits snugly
around the signal line. Pass the signal line through the Signal
Bay Pass-Throughs, place the rubber plug over the signal line,
and put the rubber plug back in place.
STEP 4:
Install the Max In-Wall Dual Signal Bay into the mounting bracket
and secure with the included screws.
Signal Protection Module Usage:
Panamax In-Wall signal protection modules (sold separately),
while not necessary for surge protection in the Max In-Wall Dual
Signal Bay, may be used to provide a clean looking interface for
the signal lines. When used in the proper manner the modules
also provide total protection to the connected equipment.
NOTE:
In order for the signal protection modules to protect against surg-
es, the ground wire on the Max In-Wall Signal Bay may be con-
nected to the ground wire on the Max In-Wall Power-PRO that is
installed nearby (less than 1 foot away). Simply connect it with the
same wire nut that is used to connect the Max In-Wall Power-PRO
to the building wire.
1
PANAMAX MAX IN-WALL DUAL SIGNAL BAY INSTALLATION INSTRUCTIONS
INS00811 REV A 03/07
STEP 5:
Repeat steps 1-4 for the Dual Signal Bay located at the source
components.
