DYNISCO UPR800 Series Instruction Manual
Page | 71
SECOND ANALOG OUTPUT RANGE HIGH - Group 3
Available:
Only if SO.TYP is different than OFF.
Upper display:
Range high for second analog output.
Lower display:
SO.HI
Range:
from 0 to PI.FSV (if SO.LNK = PrI.In) from -1000 to 3000 (if SO.LNK -
SEc.In).
Default value:
PI.FSV.
SERIAL COMMUNICATION INTERFACE ADDRESS - Group 3
Available:
Only if serial communication interface is fitted.
Upper display:
Serial communication interface address
Lower display:
SC.ADR
Range:
OFF, 1, 2, …, 255. Off disables serial interface
Default value:
Off
PROTOCOL TYPE - Group 3
Available:
Only if SC.ADR is different than off
Upper display:
Protocol type
Lower display:
SC.BUS
Range:
nodbS, JbuS. Modbus/Jbus selection
Default value:
Modbus
COMMUNICATION TYPE - Group 3
Available:
Only if SC.ADR is different than Off
Upper display:
Number of bits
Lower display:
SC.FRM
Range:
8, 8 E, 8 O. 8 bit without parity, 8 bit + even parity, 8 bit + odd parity
Default value:
8 bit without parity
COMMUNICATION BAUD RATE - Group 3
Available:
Only if SC.ADR is different than Off
Upper display:
Baud rate
Lower display:
SC.BDR
Range:
600, 1200, 2400, 4800, 9600, 19200
Default value:
19200
LOADING DEFAULT DATA - Group 3
Available:
Only if access to level 3 is allowed
Upper display:
OFF
Lower display:
DEFLT
Range:
Use
u t
keys to switch the upper display from OFF to On 3, then
press FUNC key to load the default data of the parameters belonging
to group 1, group 2, group 3
12.4 Group 4 Parameters