DYNISCO UPR800 Series Instruction Manual
Page | 63
Group 4
Function
As Set
SHUNT Shunt
Calibration
SHNT.% Shunt
Value
Pl.IFS
Primary Input Fail Safe
SI.IFS Secondary
Input
Fail
Safe
A1.HYS Alarm
1
Hysteresis
A1.RES
Alarm 1 Reset Mode
A1.FSM
Alarm 1 Failsafe Mode
A2.HYS Alarm
2
Hysteresis
A2.RES
Alarm 2 Reset Mode
A2.FSM
Alarm 2 Failsafe Mode
A3.HYS Alarm
3
Hysteresis
A3.RES
Alarm 3 Reset Mode
A3.FSM
Alarm 3 Failsafe Mode
LI.TYP Logic
Input
Configuration
LI.STS Logic
Input
Status
PEAK Peak
Detection
PI.DUT
Pressure Input Display Update Time
SI.ST
Secondary Temperature Input Sample Time
LINE.F Line
Frequency
LINE.R
Line Frequency Readout
DEFLT
Loading Default Data
Group 5
Function
As Set
PI.TYP Primary
Input
Selection
SI.TYP Secondary
Input
Selection
SI.FNC Secondary
Input
Function
MO.TYP
Main Analog Output Selection
SO.TYP
Second Analog Output Selection
DEFLT
Loading Default Data
Group 6
Function
As Set
PB.LOC
Pointer Location Selector
IN. 0
Pointer Value
DEFLT
Loading Default Data
For your convenience, use
As Set
column to enter your individual settings.
12.1 Group 1 Parameters
ALARMS MASK RESET - Group 1
Available:
Only if one or more alarms are configured with mask at start-up
Upper display:
OFF
Lower display:
AL.MSK
Range: Use
the
u
/
t
keys to switch the upper display from OFF to rESEt,
then press the FUNC key to restore the alarm mask.
Default value:
Not applicable
SECURITY - Group 1
Available:
Only if CODE.A or CODE.B or CODE.C are On.
Upper display:
A b C or A b C. or A b. C or A. b. C. One or more letters followed by
a decimal point means that the access to modification of the
parameters of the related security level is inhibited.
Lower display:
SECUR
