DYNISCO UPR800 Series Instruction Manual
Page | 55
- Firmware revision
- Pressure input counts
- Zero, for the strain gage input (P.ST.ZE)
- Span, for the strain gage input (P.ST.SP)
- Pressure (P.STR)
- Zero, for the linear inputs (P.LN.ZE)
- Span, for the linear inputs (P.LN.SP)
-
Current
(P.020)
- Voltage, 0-10V (P.010)
- Secondary input counts
- Zero, for the strain gage input (S.ST.ZE)
- Span, for the strain gage input (S.ST.SP)
- Pressure (S.STR)
- Zero, for the linear inputs (S.LN.ZE)
- Span, for the linear inputs (S.LN.SP)
-
Current
(S.020)
- Voltage, 0-10V (S.010)
- Thermocouple and RTD (S.TC.PT)
- Reference junction (S.RJ)
- Line resistance for RTD (S.RL)
- Line frequency (FREQ)
- Digital inputs status (DIG.IN)
- Maximum power consumption
- Minimum power consumption
(2) The display values for analog inputs are scaled from 0 to 25000 counts; the read-out
is linear also for the RTD inputs.
(3) Use
the
u
or
t
keys to select a display value from 0 to 10 and to check the linearity
of output circuit at 0%, 10%, .. 90% and 100% of full scale value +/- 0.05% of full
scale value.
9.3 RS-485 (Optional)
The UPR800 is available with an RS-485 Digital communications port. The configuration
parameters for this option are found in the Group 3 parameters only if this option is
included. The UPR800, when equipped with this option, is compatible with Modbus and
Jbus protocols, the choice of which is made in the Configuration/Setup menu. The
Modbus/Jbus Communications manual is available on request.
9.3.1 Serial Communication Interface Address
This function is used to set the serial Communication Interface Address. To view or
access this function, press the
FUNC
key until
nonE
and
GROUP
show on the display.
Press the
t
key until
3
shows in the upper display. Press the
FUNC
key and the lower
display changes to
SC.ADR
. The upper display shows
OFF
. Press the
u
or
t
keys
until the upper display changes to the appropriate address, from 1 to 255. Press the
FUNC
key to store the value, and to view the next parameter. If finished, press
RESET
to
return to the operating screen.
