DYNISCO UPR800 Series Instruction Manual
Page | 6
Wiring
•
Connect the wires from transducer cable as shown in the terminal diagram,
turn the screws with a torque between 1.0 and 1.2 Nm.
•
Connect an appropriate length of thermocouple extension wire (Type J) to the
connector.
•
Connect the thermocouple to the appropriate terminals (remember that red is
negative).
•
Connect alarm(s) if applicable. Note that alarm defaults are High, Reverse
Acting.
•
Connect power to the appropriate terminals as shown.
Scaling
•
Apply power to the instrument; Upper display will give a reading near zero.
Lower display will read the actual temperature.
•
Press FUNC key until the Upper display reads NONE.
Lower display reads GROUP.
•
If your transducer is not a 10,000-psi model, select Group 3 using the Up
arrow, enter with function key.
•
Lower display reads PI.FSV (Full Scale Value), and the upper display reads
10,000.
Note:
If your transducer is a 10,000 psi model skip next two steps.
Scroll to GROUP.
•
Using the Down arrow key set the appropriate Full Scale Value for your
transducer.
•
Enter using the FUNC key to scroll until GROUP legend appears again.
•
Using Up arrow key, select GROUP 2.
Calibration and Operation
•
Lower display reads ZERO.C and upper display reads OFF. Be sure
transducer is at operation temperature and that no pressure is
applied.
•
Change upper display to ON by using the Up arrow key. Enter with
the FUNC key. After a few seconds, the lower display will show
SPAN.C and upper display will show OFF.
•
Change upper display to ON using Up arrow key. Enter with the
FUNC key. In a few seconds lower display shows DSP.FL and
upper display shows 0.4. Calibration is complete.
•
Using the FUNC key, scroll to the GROUP display. Enter 1 with the
Up arrow, and enter with the FUNC key. Instrument shows 0 (±10)
on upper display and temperature on lower display. System is ready
for use.
References to Profibus features and instructions should be ignored. Profibus is being
considered for a future line expansion and has been accommodated in the current design.