DURKOPP ADLER 610-10, Operating Instructions Manual

Page: 119 / 148

Troubleshooting
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 117
1008 Error Sewing motor encoder error • Replace the encoder
1010 Error Sewing motor synchronization
error:
• External synchronizer plug
(Sub-D, 9-pin) not connected
• Connect plug of external
synchronizer to controller,
use correct connection (Sync)
• Replace the reference switch or
synchronizer
• Only required for machines with
transmission!
1011 Error Sewing motor synchronization
error (Z pulse) • Switch off the controller, use
handwheel to turn and switch on
the controller again
• If error is not corrected, check
encoder
1012 Error Sewing motor synchronization
error • Replace the synchronizer
1051 Error Sewing motor timeout:
• Cable to sewing motor
Reference switch defective
• Reference switch defective
• Replace the cable
• Replace the reference switch
1052 Error Sewing motor overcurrent:
• Sewing motor cable defective
• Sewing motor defective
• Controller defective • Replace the sewing motor cable
• Replace the sewing motor
• Replace the controller
1053 Error Sewing motor overvoltage • Check the mains voltage
1054 Error Internal short circuit • Replace the controller
1055 Error Sewing motor overload (I²T):
• Sewing motor not moving freely
or blocked
• Sewing motor defective
• Controller defective
• Remove the cause of the stiff
movement or blockage
• Replace the sewing motor
• Replace the controller
1056 Error Sewing motor overtemperature:
• Sewing motor not moving freely
• Sewing motor defective
• Controller defective • Correct the cause of not moving
freely
• Replace the sewing motor
• Replace the controller
1058 Error Sewing motor speed greater
than setpoint:
• Reference switch defective
• Sewing motor defective • Replace the reference switch
• Replace the sewing motor
Code Type Possible causes Remedial action