DURKOPP ADLER 610-10, Operating Instructions Manual

Page: 122 / 148

Troubleshooting
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 120
2174 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2175 Error Magnet wheel search • Check the connection
• Test stepper motor phases
(R = 2.8
Ω
, high impedance to
PE)
• Replace the encoder
• Replace the stepper motor
• Replace the controller
2177 Error Stepper motor overload (I²T) • Remove the cause of the stiff
movement or blockage
• Replace the stepper motor
• Replace the controller
2178 Error Encoder error • Check the connection of the
encoder cable and replace, if
necessary
• Replace the controller
2179 Error Current sensor:
• Stepper motor card defective
• Controller defective • Replace the controller
2180 Error Direction of rotation • Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine distribu-
tor and change it, if necessary
• Test stepper motor phases and
check for correct value
2181 Error Error in the reference run • Replace the reference switch
2182 Error Stepper motor current error • Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the stepper motor
2183 Error Stepper motor overcurrent • Replace the sewing motor cable
• Replace the stepper motor
• Replace the controller
2184 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
Code Type Possible causes Remedial action