DURKOPP ADLER 610-10, Operating Instructions Manual

Page: 126 / 148

Troubleshooting
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 124
2287 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2288 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2302 Error Z-axis stepper motor:
• Stepper motor not moving
freely or blocked
• Encoder cable not connected
or defective
• Stepper motor cable not
connected or defective
• Encoder defective
• Stepper motor defective
• Remove the cause of the stiff
movement or blockage
• Check the encoder cable and
replace, if necessary
• Replace the encoder
If the stepper motor is not supplied
with current:
• Check the stepper motor cable
and replace, if necessary
• Replace the stepper motor
2303 Error Z-axis stepper motor step losses:
• Stiff mechanical movement or
blockage
• Remove the cause of the stiff
mechanical movement or
blockage
2321 Error Z-axis stepper motor:
• Encoder plug (Sub-D, 9-pin)
not connected or defective
• Encoder defective
• Check the connection of the
encoder cable and replace,
if necessary
2322 Information Magnet wheel search timeout • Check connection cables
• Check stepper motor for stiff
movement
2330 Error Z-axis stepper motor not
responding • Performing a software update
• Replace the controller
2352 Error Z-axis stepper motor overcurrent • Replace the stepper motor
2353 Error Excess voltage • Check the mains voltage
2355 Error Z-axis stepper motor overload
(I²T):
• Stepper motor not moving
freely or blocked
• Stepper motor defective
• Controller defective
• Remove the blockage or the
cause of the stiff movement
• Replace the stepper motor
• Replace the controller
Code Type Possible causes Remedial action