DURKOPP ADLER 610-10, Operating Instructions Manual

Page: 74 / 148

Settings via software
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 72
9. When all sewing steps have been programmed, tap the END
button or cut off the thread.

There are 3 variants for the sewing program response -
depending on the user's input method:
10. If the thread was not cut after sewing, the message
Cut off
thread
appears.

The message is cleared, and the following selection window
appears:
Fig. 42: Creating a new sewing program, selection window
Variant Program display
The last programmed sewing step was sewn,
but thread was not cut off, and program was
ended with
END .
Continue with 10.
The last programmed sewing step was sewn,
and thread was cut off. Continue with 11.
All sewing steps were input manually and
ended with
END .
Continue with 11.