S e c t i o n 2 . 2 : C ha ng i n g H o w t h e N T 9 0 1 0 W o r k s F o r U s e r s
2 7
Door Chime Zone Attribute. . . . . . . . . . . . . . . . Sections [101] to [132], Option [3]
Verbal Chime Enabled/Disabled. . . . . . . . . . . . . . . . . . . . .Section [017], Option [2]
Verbal Chime for Zone Openings . . . . . . . . . . . . . . Section [807]-[002], Option [2]
Verbal Chime for Zone Closings . . . . . . . . . . . . . . . Section [807]-[002], Option [3]
[*] [5] Programming Access Codes
All access codes can be programmed using the [
✱
][5] command. For complete instructions
on programming access codes, see the
NT9010 User’s Guide
(“Programming Access
Codes”). For information on access code attribute programming, see
2.2.2 Access Codes
on page 19.
[*] [6] User Functions
To program user functions, perform the following:
1. Press [
✱
] [6] [Master code]. The keypad will flash the ‘System’ light.
2. Press the number [1] to [7] for the item to be programmed.
•
[1] - Time and Date
See the
NT9010 User’s Guide
for instructions on setting the time and date (“Setting
the Time and Date”).
•
[2] - Auto-Arm Enable/Disable
Enter [2] to enable (three keypad beeps) or disable (one long beep) the auto-arm fea-
ture.
•
[3] - Auto-Arm Schedule
Enter [3] to change the auto-arm time.
Enter the auto-arm time in 24-hour format (i.e. enter a 4-digit number in [hhmm]
format).
•
[4] - System Test
For step-by-step instructions on performing a system test, see the
NT9010 User’s
Guide
(“Full System Test”). When [4] is pressed the system will perform the following:
■
sound the alarm output for two seconds
■
light all lights on the keypad
■
sound the keypad buzzer for two seconds
■
test the NT9010 battery
■
send a System Test Reporting code, if programmed
(
see
2.3.12
CommunicatorReporting Codes
on page 42
)
.
•
[5] - Enable DLS (Downloading)
When [5] is pressed the system will turn on the downloading option for 1 or 6 hours.
During this time the system will answer incoming downloading calls
(
see
2.3.14
Downloading*
on page 46
)
.
• [6] – User-Initiated Call-Up
When [6] is pressed, the system will initiate a call to the downloading computer.
•
[7] Telephone Volume Control
You can change the volume of the voice prompts heard when you access the
NT9010 system by telephone. When you press [7], the NT9010 will prompt “Phone
Volume is High. To change phone volume, press ‘1’. To exit press #.”
Options are ‘Low’, ‘Medium’, and ‘High’, with ‘High’ as the default. You can change
the current selection by pressing [1].