Doosan DBC 130 II, Installation Manual

Page: 103 / 122

101
DBC 130II DBC130II ISE41
②
Front/Rear Position
Use the front/rear positioning bolts to adjust
the front/rear position and straightness of
the rail spreading between ATC rail and
column.
▪
If there is a difference between upper and
lower sections of the rail, use the height
bolt to adjust the height before proceeding
with the front/rear position and
straightness.
③
Adjusting the distance
Use the left/right positioning bolts to adjust
the gap between ATC rails to 1mm.
▪
If the gap comes significantly from the
height difference, use the height bolt to
adjust the height between two rails first.
④
When you are sure about the height, front/rear position, left/right position and
straightness between two rails, tighten all the height bolts evenly by a half turn and
tighten all the fixing bolts.
⑤
Check the height, front/rear position, left/right position and straightness between two
rails again and fine-tune the positions correctly.
⑥
Try operating the rail locating pin in ATC manual mode and check if there occurs an
interruption in this process.
⑦
If you find no further error, tighten all the adjusting bolts and fixing nuts.
Bolt 고정용
Nut
ATC
Fixing
Bolt
Height
Adjusting
Bolt
Bolt Fixing
Nut