Docomo FOMA P701iD, Manual

Page: 49 / 580

47
Confirming
before
Use
Press and hold for at least one second.
After the Wake-up display (see page 130) is displayed, the Stand-by
display appears.
●
If the clock is set, the current date and time are shown. When Set Time
is set to “Automatic”, the time is automatically corrected.
●
When “ ” is displayed, the FOMA phone is out of the service
area or in the place where the radio waves do not reach. Move to
a location where “ ” disappears.
●
When “PIN1 code entry set” of “PIN setting” (see page 150) is set to “ON”, enter your four- to eight-digit PIN1 code after you
turn on the power. When your PIN1 code is correctly entered, the Stand-by display appears. See page 148 for PIN1 code.
●
When “Auto reset setting” of “Notice call cost” is set to “ON”, enter your four- to eight-digit PIN2 code after you turn on the
power. When your PIN2 code is correctly entered, the Stand-by display appears. If you press or without
entering your PIN2 code correctly, “Auto reset setting” is set to “OFF” and the Stand-by display appears.
See page 148 for PIN2 code.
●
If the UIM is not attached or there is something wrong with it,
a warning message will come up.
1
<Stand-by display>
<Exit display>
When the UIM is
malfunctioning
When the UIM is not
attached or damaged
■
To turn the power off
Press and hold for at least two seconds.
The exit display appears and the power goes off.
●
You cannot turn on the power immediately after turning off the power. Wait a few seconds.
●
Depending on the usage state of your FOMA phone such as the number of stored Phonebook entries or saved messages, the
message “wait a minute” appears when you turn on the power. It may take a while for the Stand-by display to appear.
●
The radio waves become unstable when you move around during a call. Because of the nature of the digital technology, your call
might be cut off suddenly. You are recommended to use the FOMA phone with displayed.
Information
■
When you have not operated FOMA phone for a certain period
If you have not operated the FOMA phone for a certain period with the power on, the indication on the display and Private window
goes off and the Command Navigation key flickers at about five-second interval while the FOMA phone is open. The display comes
on again when you perform any operation.
●
You can set the display to remain on, for even when the FOMA phone has not been operated for a certain period, by setting
“Power saver mode” of “Display setting” to “OFF”. (See page 132)
<Power ON/OFF>
Turning Power On/Off
ディスプレイ
(Display)
バイリンガル
(Select language)
Japanese (
日本語
) ·····Switches to Japanese.
English ( 英語 ) ············Switches to English.
1
<Select Language>
Setting at purchase
Japanese
Switching to English
<Wake-up display>