Docomo FOMA P701iD, Manual

Page: 481 / 580

479
Data
Transmission
The operation below explains how to set a connection for
packet transmission without using the “
FOMA PC設定ソフ
ト
(FOMA PC setup software)”.
The packet transmission uses AT commands to carry out
the settings from a personal computer. To specify settings,
transmission software to enter AT command is required.
This operation is explained using “hyper terminal”, which
is attached to Windows
® as the standard software.
When using DoCoMo Internet access service, mopera U or
mopera, you do not need to specify an access point name
(APN) (see page 480).
You can set “caller ID notified/not notified” (see page 482)
as required. (You need to set “caller ID notified” when
using mopera U or mopera.)
<Packet transmission setting flow using AT commands>
Set an access point name (APN) (See step 7 on page 481)
Set “caller ID notified/not notified”
(See step 2 on page 482)
Set others (See page 492)
Exit the transmission software (See step 9 on page 482)
■ AT commands
●
The AT commands are used to control a modem. The FOMA
phone, which conforms to the AT commands, supports some
extended commands and unique AT commands.
●
By entering AT commands, you can carry out detailed setting for
packet transmission and FOMA phone, and confirm (display) the
setting contents.
●
If the AT commands you enter do not appear on the screen, enter
“ATE1 ”.
Confirm the COM port (See this page)
Start the transmission software that enables the entry
of AT commands [See step 3 of “Specifying an Access
Point Name (APN)” on page 480]
“
スタート
(Start)” “
設定
(Setting)” Open
“
コントロールパネル
(Control panel)”
1
To manually carry out the transmission setting, you
need to specify a COM port number, which is assigned
to the “FOMA P701iD” modem embedded after you
install the P701iD transmission setup file. The
confirmation method varies depending on the operating
system of your personal computer.
●
When using DoCoMo Internet access service, mopera U
or mopera, you need to specify no access point name
(APN); therefore, you do not need to confirm the modem.
Confirm that “FOMA P701iD” is set up, then
click the “
検出結果
(Search result)” tab.
3
Open “
モデム
(Modem)” in “
コントロールパネ
ル
(Control panel)”.
●
If no “
モデム
(Modem)” appears on the control panel, click “
すべ
てのコントロールパネルのオプションを表示する
(Display all
options of the control panel)”.
2
Confirm the COM port assigned to the “FOMA
P701iD” modem, then click “OK”.
●
The COM port number you confirmed is used to specify an
access point name (APN) (see page 480).
● The contents on the property display and COM port number vary
depending on the personal computer you use.
4
Setting Packet Transmission
Confirming COM Port Number
For Windows ® 98 and Windows ® Me
Setting Dial-up Network